Projects Made with PlasmaCAM

The "Skybike" soars over a 125 foot cliff. Click here to see how this project was made using the PlasmaCAM Cutting System!


Customer Reviews

Back to Reviews

Sandra, Ranch Owner


Rate this review:
  • Currently 3.00/5
(300 votes cast)

We used to run another machine that was a lot more of a pain than yours. We did our designs in CorelDraw and converted them into vectors, and then we took the disk to another computer that was connected to the machine. We couldn't do any designing or alterations on the computer that operated the machine. We also got a lot of instability as the cutter got to the middle of the table. We would program the cutting of multiple parts at a time, but when it froze up, we would have to start them all over! Your machine is nice because you can pick up cutting again where you want.